Kidde manual reset relay

Recovery from lockout requires a manual reset by either resetting the thermostat, or removing 24 VAC for a period of 5 seconds. On models with automatic reset, if the thermostat is still calling for heat after one hour, then the control will automatically reset and attempt to ignite the burner. Combustion Airflow Fault. The interconnect system should not exceed the NFPA interconnect limit of 12 smoke alarms and/or 18 alarms total (smoke, CO, Smoke/ CO Combination, heat, etc.). With 18 alarms interconnected, it is still possible to interconnect up to a total of 6 remote signaling devices and / or relay modules. The obligation to Kidde under this warranty is limited to repairing or replacing any part which we find to be defective in material, workmanship, or design, free of charge, to the customer, upon sending the relay module with proof of date of purchase, postage and return postage prepaid, to Warranty Service dept. Kidde Safety, Corporate.

Manual Pull Station Guards. Kidde Badger Range Guard System Parts. RESET RELAY. Required when using electrical gas valves, these RESET RELAYS are UL listed. Kidde Relay Module SMX, COX or both Optional Accessory releasing the test/reset button. You will hear one beep on the button push, and will then hear the. The Kidde SMX can be used to activate auxiliary warning devices such as external bells and sirens, hallway or stairway lighting. This relay will only activate when it receives a smoke signal from an interconnect Smoke Alarm. Brochure. Data Sheet Firex Combination Alarm ENG Published Date: 6/22/

Refer to the wiring instructions in section 3 for NFPA initiating device limits. Kidde. Relay Module. SMX. First. Alarm. Additional. Alarm. Optional. 4 thg 8, These relays will latch on change of state and shall remain latched until manually reset by the System Reset control switch. ASME CSD-1 compatible models available (consult factory) non-volatile lockout the reset button must be pushed or 24 VAC Valve Relay Problem.